Aftercare // Support

Aftercare

Everything that matters after discharge: firmware, remapping, swapping switches and how to reach me.

01 // Layout

Button map

This is the H-185’s factory layout, seen from above. The names (B1, S2 …) are the ones the GP2040-CE web interface uses.

←LEFT↓DOWN→RIGHT↑UP□B3△B4R1L1✕B1○B2R2L2S1S2A1A2L3R3START
H-185 from above. START is highlighted.
What each button is on each platform
ButtonPlayStationXboxSwitch
B1✕AB
B2○BA
B3□XY
B4△YX
R1R1RBR
L1L1LBL
R2R2RTZR
L2L2LTZL
S1 · SelectShare / CreateView−
S2 · StartOptionsMenu+
A1 · HomePSGuideHome
A2 · CaptureTouchpad–Capture
L3L3LSL-Stick
R3R3RSR-Stick

02 // GP2040-CE

Firmware + remapping

Every controller runs GP2040-CE, an open-source firmware. You remap buttons right in the browser, no software to install.

  1. Hold START (small button no. 2 from the left, see the button map) while you plug in the USB-C cable.
  2. Open http://192.168.7.1 in your browser.
  3. Under Pin Mapping you assign the buttons. Save, unplug briefly, done.

The web interface runs locally on the controller itself; nothing goes to the internet. Full documentation and firmware updates are here:

Documentation at gp2040-ce.info

03 // Hot-swap

Swapping switches + caps

The Kailh Choc V1 switches sit in hot-swap sockets. You don't need a soldering iron.

  1. Unplug the controller.
  2. Pull the keycap straight up, ideally with a keycap puller, otherwise carefully with your fingers.
  3. Grip the switch by its two clips with a switch puller and pull it straight out. Don’t tilt it.
  4. Check the new switch: both pins must be straight. Then press it straight into the socket until it clicks.
  5. Put the cap back on and test the button in the web interface or an input viewer.

! Only Choc V1 switches (low profile) and Choc V1 caps fit. MX parts do not.

04 // Care

Care

  • Remove dust with a soft brush or compressed air.
  • Wipe the case with a slightly damp cloth only. No alcohol, no acetone: they attack PLA.
  • Don't leave it in direct sun or a hot car. PLA starts to soften at around 55 °C.
  • Unplug by the connector, not the cable.

05 // Diagnosis

Compatibility

PC (Windows, Linux)supported
Steam Decksupported
Nintendo Switchsupported
PlayStation 5with an auth adapter in the USB-A port
PlayStation 4with an auth adapter in the USB-A port
PlayStation 3supported
Xbox One / Series X|Swith an auth adapter in the USB-A port

Everything runs on the open-source GP2040-CE firmware. PS4, PS5 and Xbox also need an auth adapter for that console (e.g. a dongle or a licensed controller) in the USB-A port. The adapter is not included.

06 // Contact

Contact

Something sticks, a button doesn’t respond, or you need spare parts? Email me with your patient number (it’s on the tag):

hello@inputclinic.com

If you bought on Etsy, a message through Etsy works too.